STARTING SYSTEM — Starter — Armature Check (Cont'd) + Assembly
EL-23prose procedureArmature Check (Cont'd)
Armature — surface, diameter and undercut
- 1Check commutator surface. Rough → Sand lightly with No. 500 to 600 sandpaper.
- 2Check diameter of commutator. Commutator minimum diameter: refer to S.D.S. Less than specified value → Replace.
- 3Check depth of insulating mold from commutator surface. Less than 0.2 mm (0.008 in) → Undercut to 0.5 to 0.8 mm (0.020 to 0.031 in).
Assembly
NOTE
Apply high-temperature grease to lubricate the bearing, gears and frictional surface when assembling the starter. Carefully observe the following instructions.
Apply high-temperature grease to:
Gear case metal
Moving portion of shift lever
Plunger of magnetic switch
Internal gear
Planetary gear
Shaft
See also
S.D.S. (EL section)