Diagnostic Procedure 17 — NEUTRAL AND INHIBITOR SWITCH (Not self-diagnostic item)
EF & EC-116wiring diagramL.H. drive model (L), R.H. drive model (R), A/T model (A), M/T model (M) variants shown in wiring diagram. Inhibitor Switch and Inhibitor Relay apply to A/T models only. Neutral Switch applies to M/T models only.
TROUBLE DIAGNOSES
Diagnostic Procedure 17
NEUTRAL AND INHIBITOR SWITCH (Not self-diagnostic item)
Neutral and Inhibitor Switch Wiring Schematic
Components (8)
E.C.C.S. Control UnitFuse BlockInhibitor RelayInhibitor SwitchNeutral SwitchBody GroundENGINE ROOM HARNESSENGINE ROOM HARNESS NO2
Connections (9)
Fuse Block
Fuse BlockInhibitor RelayG/L
Fuse BlockE.C.C.S. Control UnitG/OR
Inhibitor Relay
Inhibitor RelayE.C.C.S. Control UnitG/OR
Inhibitor RelayENGINE ROOM HARNESSG/OR
Inhibitor RelayBody GroundB
Inhibitor Switch
Inhibitor SwitchInhibitor RelayG/L
ENGINE ROOM HARNESS
ENGINE ROOM HARNESSENGINE ROOM HARNESS NO2G/OR
Neutral Switch
Neutral SwitchE.C.C.S. Control UnitG/OR
E.C.C.S. Control Unit
E.C.C.S. Control UnitBody GroundB
NOTE
Legend:
L : L.H. drive model
R : R.H. drive model
A : A/T model
M : M/T model
Connector reference markers on diagram:
B — used to indicate splice/junction points shared between diagram sections
A — A/T model specific connection point
M — M/T model specific connection point
Fuse Block note: Refer to 'POWER SUPPLY ROUTING' in EL section.
Inhibitor Switch positions visible: 1, 2, D, N, R, P (on top connector row) and lower row contacts.
NOTE
E101 note: Refer to last page foldout page.