BODY ALIGNMENT — Engine Compartment Measurement
BF-36spec tableIMPORTANT
All dimensions indicated in figures are actual ones.
When a tram tracking gauge is used, adjust both pointers to equal length and check the pointers and gauge itself to make sure there is no free play.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
Measurements should be taken at the center of the mounting holes.
NOTE
An asterisk (*) following the value at the measuring point indicates that the measuring point on the other side is symmetrically the same value.
The coordinates of the measurement points are the distances measured from the standard line of "X", "Y" and "Z".
| Specification | Value |
|---|---|
| X — Vehicle center referenceStandard line. | 0mm |
| Y — Center line of front axle referenceStandard line. | 0mm |
| Z — Imaginary base line (200 mm below datum line OZ)Standard line; 200 mm below datum line. | 0mm at imaginary base |
X — Vehicle center referenceStandard line.
0mm
Y — Center line of front axle referenceStandard line.
0mm
Z — Imaginary base line (200 mm below datum line OZ)Standard line; 200 mm below datum line.
0mm at imaginary base
Engine Compartment — MEASUREMENT
NOTE
Engine-bay measurement diagram with 20+ diagonal distances marked. Asterisked values are symmetric. See figure SBF193E for full point map.