INTERIOR AND EXTERIOR — Exterior (Cont'd) — Items 9-15 (door, sight shield, back-window moldings, sun roof)
BF-24parts diagramExterior (Cont'd)
⑨ Door weatherstrip
IMPORTANT
Apply butyl sealant where necessary while installing the weatherstrip.
⑩ Rear sight shield
NOTE
Held with sealing washers at the inner edge.
⑪ Back door window upper and side molding
IMPORTANT
Bonded on back door glass side.
⑫ Rear panel finisher
NOTE
Inner edge sealed with sealing rubber.
⑬ Back door window lower molding
IMPORTANT
Set molding fastener when windshield glass is installed. CE106 molding clip × 9 places. When installing fastener, heat body panel and fastener to approx. 30 to 40°C (86 to 104°F) before pressing onto double-faced adhesive tape.
⑭ Back door weatherstrip
NOTE
Align white marking on weatherstrip with vehicle center. Cross-section A: back-window weatherstrip + butyl seal + back-window upper garnish + body panel. Cross-section B: luggage-side upper garnish + butyl seal + body panel.
⑮ Sun roof weatherstrip & lid weatherstrip
IMPORTANT
Apply primer before bonding sealant portion. Weatherstrip-to-lid overlap dimension: 33 mm (1.30 in).
| Specification | Value |
|---|---|
| Heat-fastener install temperature (item 13)When installing back-door window lower molding fastener. | 30 - 40°C (86 - 104 °F) |
| Sun-roof weatherstrip overlap (item 15)Weatherstrip-to-lid overlap. | 33mm (1.30 in) |
Heat-fastener install temperature (item 13)When installing back-door window lower molding fastener.
30 - 40°C (86 - 104 °F)
Sun-roof weatherstrip overlap (item 15)Weatherstrip-to-lid overlap.
33mm (1.30 in)