WINDSHIELD AND WINDOWS — Windshield removal and installation
BF-28prose procedureWindshield
REMOVAL
After removing moldings, remove glass.
CAUTION
Be careful not to scratch glass when removing.
INSTALLATION
IMPORTANT
Use genuine Nissan Sealant kit or equivalent. Follow instructions furnished with it.
After installation, the vehicle should remain stationary for about 24 hours.
Do not use sealant which is more than 12 months past its production date.
Do not leave cartridge unattended after its cap open.
Keep primers and sealant in a cool, dry place. Nissan recommends that they are stored in a refrigerator.
Be sure to install moldings.
WARNING
Keep heat or open flames away as primers are flammable.
CAUTION
Allow primers to dry for 10 to 15 minutes before proceeding to the next step.
| Specification | Value |
|---|---|
| Spacer offset from corner | 25mm (0.98 in) |
| Spacer offset from vehicle center | 500mm (19.69 in) |
| Dam rubber bead width | ≈ 8mm (0.31 in) |
| Heat-fastener install temperatureWhen installing molding fastener. | 30 - 40°C (86 - 104 °F) |
| Primer dry time before next step | 10 - 15minutes |
| Vehicle stationary time after install | ≈ 24hours |
| Sealant maximum age past production date | 12months |
Spacer offset from corner
25mm (0.98 in)
Spacer offset from vehicle center
500mm (19.69 in)
Dam rubber bead width
≈ 8mm (0.31 in)
Heat-fastener install temperatureWhen installing molding fastener.
30 - 40°C (86 - 104 °F)
Primer dry time before next step
10 - 15minutes
Vehicle stationary time after install
≈ 24hours
Sealant maximum age past production date
12months