PRECAUTIONS AND PREPARATION

FA-2prose procedure

Precautions

When installing each rubber part, final tightening must be carried out under unladen condition* with tires on ground.

NOTE

* Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.

When removing each suspension part, check wheel alignment and adjust if necessary.

Use Tool when removing or installing brake tubes.

NOTE

*: Special tool or commercial equivalent

Tool number	Tool name	Illustration	Description
HT72520000*	Ball joint remover	fig2	Removing tie-rod outer end and lower ball joint
HT71780000*	Spring compressor	fig3	Removing and installing coil spring
ST35652000*	Strut attachment	fig4	Fixing strut assembly
GG94310000*	Flare nut torque wrench	fig5	Removing and installing brake piping

HT72520000*

Tool nameBall joint remover

Illustrationfig2

DescriptionRemoving tie-rod outer end and lower ball joint

HT71780000*

Tool nameSpring compressor

Illustrationfig3

DescriptionRemoving and installing coil spring

ST35652000*

Tool nameStrut attachment

Illustrationfig4

DescriptionFixing strut assembly

GG94310000*

Tool nameFlare nut torque wrench

Illustrationfig5

DescriptionRemoving and installing brake piping